Bug-o-systems Programmable Gantry System Manual de usuario descargar pdf (Pagina 5)

SETUP

The GANTRY is shipped in major assemblies, ready to assemble on your burning table. It is very important to

construct the burning table carefully; two suggested bed designs are shown on pages 31 and 32. Whichever design is

used, it is critical that:

1. The ARR-1080 Rails are mounted on strong supports, independent of the burning bed. By using a 6" (150 mm)

beam, the rails may be mounted in a straight line, by using the ARR-1050 mounting system, even though the steel

may not be perfectly straight. USE A TRANSIT when setting the rails to ensure they are both LEVEL AND

STRAIGHT.

2. After the rails are installed and checked, put the carriages one at the time on the rails. The LEFT carriage is the

one with the Controls.

3. Insert the 2 vertical columns (MUG-1053) into the column bases (MUG-1050). Place the Crossing Rail on the

columns, and bolt on loosely. With the drives disengaged, square up the gantry, level the crossing rail, and then

tighten the Crossing Rail clamps. Slide the cross drive on to the rail.

4. Connect the cables between various components, referring to diagrams on page 16.

5. Rotate the clutches on the 3 drive units to engage the pinions with the racks. The machine can now be plugged in

and run.

OPERATING INSTRUCTIONS

1. Check that the cross-beam is square to the main track. Adjust the torch position, and connect the required gas

hoses or plasma trigger connection.

2. Plug the machine into the power line of correct voltage, and push the RESET button.

3. Push the red STOP/PAUSE button and use the toggle switches to move the machine and cross drive to the

starting position. Press the RESET button to make this the starting point.

4. Set the speed knob for correct speed. Speed can be checked by moving the machine manually using the toggle

switches.

5. It the required shape has not been programmed, refer to Shape Programming, and enter the program. If the

shape has been programmed, turn on the preheat gases, set the torch height and ignite the torch.

6. When the work piece is heated enough, press the black RUN button. The solenoid will turn on the cutting oxygen,

the machine will start moving along the programmed shape, and at the end of the shape it will stop and turn off

the, solenoid. Manually turn off the preheat gases. The machine is now ready for the next cut. Note: For Plasma

Cutting, see page 25.

1 2 3 4 5 6 7 8 9 10 ... 35 36

Sin comentarios

Bug-o-systems Programmable Gantry System Manual de usuario Pagina 5